Tech Tip: Automatic slack adjusters

Dec. 14, 2017
Simple maintenance, such as greasing the slack to proper purge, can keep the ASA working smoothly and in proper adjustment and operation.

Myth: Adjust slacks at every inspection.

Fact: For fleets and drivers operating vehicles equipped with automatic slack adjusters (ASAs), do not manually adjust the ASA if the brake is beyond the stroke limit.

Some technicians servicing drum brakes will adjust ASAs at every preventive maintenance (PM) inspection. Properly installed, operating and lubricated automatic slack adjusters should never need adjusting after the initial setup – aside from during brake relining. Therefore, Bendix emphasizes that an out-of-adjustment ASA should never simply be manually adjusted to bring it back into adjustment. 

Wheel-ends beyond the maximum allowable brake stroke are considered out of adjustment, and drivers can incur fines if 25 percent of a truck’s wheel-ends are out of adjustment. Many factors can cause an ASA to be out of adjustment – including improper lubrication of the slack adjuster, cam tube and clevis pins; or excessive wear of the cam head, bushings and rollers – but it is likely that none of these will be remedied with a manual adjustment.

Simple maintenance, such as greasing the slack to proper purge, can keep the ASA working smoothly and in proper adjustment and operation.

“Maybe as a holdover from the days of manual slacks, we continue to hear stories of service technicians who believe it’s acceptable to routinely adjust automatic slacks, or this item is still on the fleet’s PM inspection form. But it’s not something you should do for ASAs,” said Keith McComsey, Bendix Spicer Foundation Brake (BSFB) director of marketing and customer solutions. “Manual adjustment may temporarily solve the out-of-adjustment issue. However, if other factors are at play, they must be addressed – otherwise the condition will reoccur. We stress, as always, how critical it is to maintain, adjust or replace slack adjusters according to the manufacturer’s instructions.”

Noting how crucial correct brake stroke is to braking performance and safe vehicle operation, Bendix advises measuring the chamber stroke on each wheel-end at every maintenance inspection. Do this by checking the distance from the chamber to the large clevis pin with the brakes released, and again after a full brake application. The difference between the two measurements is the chamber stroke. The maximum allowable stroke under CVSA guidelines is based on the chamber size and type.

To check the free stroke of the brake, refer to the manufacturer’s service data sheet. Pull the actuator pushrod to confirm that approximately one-half inch of pushrod-free stroke exists. The measurement of free stroke is an indication of shoe to drum gap on the brake. This is an indication of how the brake is maintaining adjustment.

As a guide, refer to the Technology & Maintenance Council (TMC) recommended practices (i.e., RP-609) for further details on inspection and maintenance. If it is necessary to spec a replacement ASA because out-of-adjustment brakes are an ongoing problem, again follow the TMC recommended practices.

Information provided by: Bendix

Sponsored Recommendations

Fleet Maintenance E-Book

Streamline your fleet's maintenance and improve operations with the Guide for Managing Maintenance. Learn proven strategies to reduce downtime, optimize in-house and third-party...

Celebrating Your Drivers Can Prove to be Rewarding For Your Business

Learn how to jumpstart your driver retention efforts by celebrating your drivers with a thoughtful, uniform-led benefits program by Red Kap®. Uniforms that offer greater comfort...

Guide To Boosting Technician Efficiency

Learn about the bottom line and team building benefits of increasing the efficiency of your technicians in your repair shop.

The Definitive Guide to Aftertreatment Diagnostics

Struggling to clear aftertreatment fault codes? Learn more about different aftertreatment components, fault codes, regen zones, and the best maintenance practices to follow.