342265415 | Vitpho | Dreamstime.com
672cc3017c4a21b4564a5d6e Dreamstime L 342265415

Top 12 tips to prepare your fleet for winter

Nov. 7, 2024
You can’t control the weather, but you can control how you prepare for it by making sure that every vehicle in your fleet is in the best condition possible.

Will this winter bring milder temperatures with fewer snowstorms? We certainly hope so, but fleets must be prepared for the worst by properly winterizing their vehicles. You can’t control the weather, but you can control how you prepare for it by ensuring every vehicle in your fleet is in the best condition possible.

Snow and ice storms mean more accidents, more closed roads and highways, and less product delivered on time. Less product delivered on time can wreak havoc on your fleet’s customer relationships and negatively impact the bottom line. There’s also the cost of necessary weather-related repairs.

Don’t wait for the first freeze to take these steps:

  • Choose the right diesel fuel. Diesel contains paraffin, which causes fuel to gel as temperatures drop. Check with your fuel supplier to be sure it has the right blend of winter fuel. Also, anti-gel additives can be used during the winter months. Be sure to check with your engine manufacturer to get recommendations on fuel treatment, as some can cause damage to high-pressure fuel systems.
  • Check your water separator daily. Diesel fuels have water suspended in the solution. The water comes from condensation that forms inside a cold fuel tank with warm fuel. To minimize the risk, check your water separator daily.
  • Test your coolant system. If you haven’t done it already, make sure your local service provider performs a comprehensive winterization inspection of the cooling systems. A coolant test will make sure your coolant is at the optimum freezing point protection for your needs. The inspection should also include the radiator, hoses, belts, and coolant filter replacement.
  • Use a block heater when the truck is parked. Diesel engines are harder to start than vehicles that run on gasoline because of the diesel engine’s need for higher cylinder temperatures and cold engine oil. Therefore, when the vehicle is parked for any length of time in cold weather, an engine block heater should be used to minimize cold starting conditions.
  • Perform air-dryer maintenance. The air dryer is designed to remove moisture and contaminants from entering the vehicle air system, including the brake system. Drain the moisture from air tanks routinely to help prevent water from freezing in the lines and contaminants from entering air valves. Excessive moisture can indicate an air dryer malfunction or a bad filter. Air dryer maintenance is imperative and should be maintained according to the interval schedule listed in the owner’s manual.
  • Check battery age and lifecycle and frequently check the health. Cold engines are harder to turn, which requires more power from the battery. Cranking a cold engine increases amperage draw and decreases voltage—not a good combination if your battery is not fully charged. Therefore, it is essential to check the battery frequently.
  • Check battery life. Battery life is greatly affected by temperatures, vibration, and the amount of deeper discharge cycles. The deeper the battery discharge and the greater the number of discharges, the shorter the battery life. A discharged battery can start to freeze around 32 degrees, but a fully charged one will only start freezing at very cold temperatures. Keep those batteries charged.
  • Allow for reduced PSI due to cold weather and inflate tires accordingly. Tire pressure can change some 2 psi for every 10 degrees of temperature change. As the temperature falls, so does the tire pressure. Underinflated tires reduce the tire load capacity, wear faster, and generate more heat— one of the major causes of tire failure. However, overinflating can increase impact breaks and road debris damage. To get tire pressure just right, refer to the tire manufacturer’s data chart for the weight carried, and make sure you put the right amount of air in the tires.
  • Perform preventive maintenance. Always follow the OEM’s recommended maintenance schedule. Even if you follow all of the steps listed above, breakdowns can still happen during treacherous winter conditions.
  • Select a breakdown service provider that will be there whenever you need them. Find one that has your servicing area covered, experienced technicians, and 24/7/365 service available.
  • Be prepared. Each driver should be prepared for the worst in the winter. Be ready for road closures, gridlock, emergency breakdowns, etc. An unexpected blizzard in whiteout conditions could occur when you’re in the middle of nowhere with no one around, and your truck breaks down.
  • Take care of yourself. Drivers need to take care of themselves as well as their vehicles in case of an emergency slowdown or breakdown. Be prepared with safety gear: flashlights, beverages, food, an extra day's supply of medications, blankets, snow preparation, spare cell phone battery charger, etc.

Remember, there’s only so much time to get prepared.

This article originally appeared on FleetOwner.com.

About the Author

Jane Clark | vice president, member services for NationaLease

Jane Clark is vice president, member services for NationaLease. In this position, she is focused on managing the member services operation, as well as working to strengthen member relationships, reduce member costs, and improve collaboration within the NationaLease supporting groups. Prior to joining NationaLease, Jane served as area vice president for Randstad, one of the nation’s largest recruitment agencies, and before that, she served in management posts with QPS Companies, Pro Staff, and Manpower, Inc.

Sponsored Recommendations

Fleet Maintenance E-Book

Streamline your fleet's maintenance and improve operations with the Guide for Managing Maintenance. Learn proven strategies to reduce downtime, optimize in-house and third-party...

Celebrating Your Drivers Can Prove to be Rewarding For Your Business

Learn how to jumpstart your driver retention efforts by celebrating your drivers with a thoughtful, uniform-led benefits program by Red Kap®. Uniforms that offer greater comfort...

Guide To Boosting Technician Efficiency

Learn about the bottom line and team building benefits of increasing the efficiency of your technicians in your repair shop.

The Definitive Guide to Aftertreatment Diagnostics

Struggling to clear aftertreatment fault codes? Learn more about different aftertreatment components, fault codes, regen zones, and the best maintenance practices to follow.